Singer XL-6000 Instruction Manual page 118

5. (Setting for embroidery)
• Changing letters size:
Standard size of letters and numbers stored in machine can be specified.
• Letter density:
Embroidering density of letters stored in machine can be specified.
• Setting of number of stitches needle moves back for correcting stitches :
The number of stitches needle moves back when faulty stitches need to be
corrected can be specified.
• Initial setting of thread tension:
Initial setting of thread tension for automatic mode can be specified.
Press pictogram, and
following screen will appear.
6. (Setting for embroidery)
• Setting of automatic winding of exclusive bobbin thread:
It is possible to set whether or not machine automatically winds bobbin when
bobbin thread has run out during embroidery.
Additionally, initial setting of bobbin thread winding amount can be specified.
* To completely use bobbin thread remaining on bobbin, machine may
automatically sew along edge of embroidery frame before winding bobbin.
* In the case where automatic bobbin winding is set to "off" machine will stop em-
broidery when bobbin thread has run out. In this case, machine will wind bobbin
when bobbin winding key is pressed.
• Setting of thread trimming:
It is possible to set whether or not machine automatically trimming transition thread
between patterns.
• Setting of Data Transfer Speed from Computer to Sewing Machine.
Press pictogram to b
proceed to "1" on next page.
4
117