Thread Exchanger (Standard Machine) - Singer XL-6000 Instruction Manual

Thread Exchanger (Standard Machine)
Press rewind switch to
automatically rewind thread.
* When sewing embroidery,
please see page 63,64.
* Do not touch needle thread
rewind device during rotation.
* When the Thread Exchanger
stops during re-winding, turn
the power to the machine off,
confirm the setting of the
thread and then turn the power
back on.
Install Threa_
Exchanger. =_
1
2
InstalIThread Spools.
In case
of normal Large
thread p
spool
_Lar e
inner ca_
_Small
cap
.J
Place thread so thread wraps Place thread so thread wraps Place thread so thread
around spool in a clockwise around spool in a clockwise wraps around spool in a
direction and put large cap direction and put large cap clockwise direction and
onto thread spool• onto thread spool after put small cap onto
installing inner cap. thread spool•
_Occasionally when using small spools of thread, the last 10 - 15% of thread will not
reel off smoothly• When this occurs, use the Auxiliary Spool Pin. Mount the Spoo P n
on the Accessory Bobbin Winder Shaft and install on machine•
Stage Thread
for Automatic
3
Threading.
Holding thread with fingers, pull
thread so as to stretch thread tight•
Thread sewing machine Lower presser foot.
along groove, pull it in
direction of arrow and cut _/
it with thread cutter blade. 5 Press V_J key.
' i
t
6
Press
pictogram.
Press picto to rewind thread to left thread spool.
Press picto to rewind thread to right thread spool.
* Press rewind picto after confirming that thread is cut.
12