Picture-In-Picture Controls - Extron electronics IN1508 User Manual

Picture-in-Picture controls

PIP buttons —
4
PIP
ON
Figure 3-5 — Picture-in-Picture buttons
On button — The PIP On button toggles the PIP function on and off.
If you press and hold the PIP On button while you apply power to the
switcher, the switcher toggles the output signal type between RGB and
progressive component video. If an RGB signal type (RGBHV, RGBS, or
RGsB) was selected the last time the switcher was powered, the signal type
switches to component. If component video was selected, the signal type
switches to RGB.
The audio breakaway switching function, normally available under RS-232
control only, is not available when the PIP function is on.
On LED — When lit, the PIP On LED indicates that the switcher's PIP
function is on.
Swap button — The PIP Swap button toggles the primary and secondary
pictures between the main image and the PIP window.
With regard to the PIP function, there are two groups of inputs:
•
•
The PIP function toggles between the selected input in each group. The PIP
function cannot toggle between two inputs in the same group.
The size of the PIP window is set in the menu system, see "PIP Mode selection
box", on page 3-24, for details. The position of the PIP window is set with the
centering adjustment; see "Picture adjustments", on page 3-25, for details.
If PIP mode is off (the PIP Mode On LED is off), the Swap function continues
to work, toggling between the most recently selected low-resolution input and
the most recently selected high-resolution input. Unlike when PIP mode is on,
however, the input that is replaced in the main window is not displayed in the
PIP window.
SWAP
Low resolution — Inputs 1 through 4 (and input 5 if it is configured as
interlaced component video; see "Input 5 selection" on page 3-18)
High resolution — Inputs 6 through 8 (and input 5 if it configured as
progressive component video/HDTV; see "Input 5 selection" on
page 3-18)
IN1508 Scaling Presentation Switcher • Operation 3-5