Swap Selection; Pip Mode Selection Box; Fade Switch Selection Box; Blue Mode Selection Box - Extron electronics IN1508 User Manual

Operation, cont'd

Swap selection

The Swap selection toggles the primary and secondary inputs between the main
image and the PIP window. Select swap by highlighting the Swap selection and
pressing the Enter or
between the main and PIP windows. Press the , , or
or allow the menu timeout (from the final button push) to clear the on-screen
displays. This on-screen display's function is identical to pushing the front panel
Swap button.

PIP Mode selection box

The PIP Mode selection box displays the currently selected size and position for the
picture-in-picture window (if PIP mode is turned on) and allows you to select
another size and position.
Use the front panel or IR remote control
size and position and press the Enter button.

Fade Switch selection box

The Fade Switch selection box provides the ability to select between cuts and fades
when you select a new input. A fade switch fades the output to black, switches to
the new input, and then fades in from black. A cut selects the new input with no
masking affect.
Use the front panel or IR remote control
switches or Off for cuts and press the Enter button.

Blue Mode selection box

The Blue Mode selection box provides the ability to turn the blue mode feature on
and off. Blue mode is helpful in the setup of the color and tint of the incoming
video signal. In the blue mode, only the sync and blue video signals are passed to
the display. Use the front panel or IR remote control
or Off and press the Enter button.

Reset selection box

The Reset selection box provides the ability to perform a system reset. Reset
returns the output rate selection to the XGA, 1024 x 768 at 60 Hz, setting; resets the
picture controls to their default values; sets all input audio levels to 0 dB; and
selects input 1. Use the front panel or IR remote control
Ok and press the Enter button to perform the reset or select Cancel and press the
Reset button to exit the screen without performing the reset.
3-24 IN1508 Scaling Presentation Switcher • Operation
button. Repeatedly press the Enter or
If PIP mode is off (the front panel PIP Mode On LED off), the Swap function
continues to work, toggling between the most recently selected low-resolution
input and the most recently selected high-resolution input. Unlike when PIP
mode is on, however, the unselected input is not displayed in a PIP window.
The two side-by-side options are available only via this menu or a Simple
Instruction Set command (see chapter 4, "Serial Communications"). If either
side-by-side option is selected, the PIP size adjustment does not work.
button to toggle
button to deselect Swap,
and buttons to highlight the desired
and buttons to select On for fade
and buttons to select On
and buttons to select