Setting The A/V Network - Mitsubishi TS-4545 Owner's Manual

Setting the AN Network
The A/V Network is a system that Mitsubishi developed to make it
easier to operate many products with one remote control. When the
A/V Network is connected between two Mitsubishi products, you
can point the remote control at one product and it will °pass" the
remote control command to the other. To set up the A/V Network:
0 Press the MENU button on the
[] First Time Setup
[] Set the Clock
[] Memorize Channels
[] Add!delete Channels
[] Set AN Network
[] Align Colors
] ADJUST to select
I_q ENTER to enter
F_q MENU to go back
O
O
remote control. The Main Menu
will appear on the screen.
Use the ADJUST buttons to
select "First Time Setup." Press
ENTER.
Use ADJUST to select "Set A/V
Network"; then press ENTER.
[] Set A/V Network
[] o.
[] Basic
[] Active
-----] DJUST to select
ENTER to enter
I_q MENU to go back
O
Use the ADJUST buttons to
select "Active," "Ba,;ic," or "Off."
Check the rear ternfinals of
your VCR, then use the chart
below _o determine how you
should set your Prqiection TV.
Press the ENTER or MENU
P>Important:
_Important:
_Important:
If your VCR has a rear ...and you have set your ...then set your TV to:
terminal that reads: VCR to:
Basic
A/V Network
Active A/V Network Off Basic
Active A!V Network Active Active
Does not have an A/V - Off
Network rear terminal
If you are not sure how to set your VCR's ?ffV Network setting,
refer to your VCR's owner's guide.
The A/V Network can still be used to pass remote control signals
even when the Projection TV's "A/V Network" setting is "Off."
If you do not use the A/V Network system, set "A/V Network" to
"Off." If you don't, channel selection may not work correctly.
If you select the Active or Basic A/V setting, make sure your
Mitsubishi VCR with an A_7 Network or Active A/V network
connection is connected to Input-1 and the A/V network cable is in
place.
Getting Started 57