Mitsubishi TS-4545 Owner's Manual page 93

Selecting source of the PIP image
0 Turn your VCR on.
O Turn the PIP image on.
Pre,_s the SOURCE button on
the remote control repeatedly
until the VCR picture appears
in the PIP image
0 If you want to se].ect a source
other than the VCR, continue
pressing the SOURCE button.
The source will change as
follows::
L,- TV _ INPUT-1 --÷ INPUT-2--_ INPUT-3 J
_>Important:
bImportant:
DImportant:
To change the main image while a PIP image is displayed, press
the input button (INPUT) on the control panel or on 1:he :remote
control.
To see two different channels at the same time, you must:
• connect a second tuning source (such as a VCR) to an input as
shown in the connection diagrams in Chapter 2 of this manual;
• use the SOURCE button to select the input for the seomd tuning
source.
You cannot select Antenna B as a PIP source when watching
Antenna A as the main image.
94 Chapter 4: Using the Special Features