Using The Active A/V Network Feature - Mitsubishi VS-5041 Owner's Manual

Using the Active AN Network Feature
_>Important:
This A/V Network is a special feature that makes it easier to use
your Projection TV and your other A/V components together. When
you connect tile A/V Network, you can poinl; the remote control at
the Projection TV, and it will "pass" the remote control command to
the other components.
Additionally, you will gain even more benefits if you have a Mitsu-
bishi VCR equipped for the Active A/V Network. The Active A/V
Network allows you to perform many of the commonly used fea-
tures of your system at the press of just one button.
This section will explain the various features of the Active A/V
Network.
before you begin
You must have connected an A/V Network cable from the Active
A/V Network terminal of your Projection TV to the A/V Network
IN terminal of your VCR. See "TV + Mitsubishi products that
have A/V Network terminals," page 40.
• You must have connected your VCR to External 1 (EXT-1) of
your Projection TV.
° You must have set your Projection T_Ps "A/V Network" setting
to "Active" or "Basic." See "Setting the A!V Network," page 59.
• Your VCR's remote contrvl switch (if any) should be set to
"VCR-A."
• Your VCR's video mute setting should be turned ON.
what the Active AN Network does
The Active AIV Network makes it easier and faster to use the
VCR's Quick Program and Play commands and the Projection TV's
PIP commands.
When using the Active A/V :Network, you should always point your
remote control at your Projection TV.
Using the Active A/V Network Feature 91