Setting The A/V Network - Mitsubishi S6085 Operating Manual

Setting the A/V Network
The A/V Network is a special system that Mitsubishi developed to
make it easier to operate many products with one remote control.
When the A/V Network is connected between two Mitsubishi
products, you can point the remote control at one product and it
will "pass" the remote control command to the other. To set up the
A/V Network:
[] FIRSTTtME SET UP
_ emorize Channels
Set the Clock
Add!Delete Channet
Set AN Network
Set up Cable Box
Align Colors
Use these buttons on the remote:
--_ ADJUST [] ENTER _ MENU to
to select to enter go back
O
O
O
[] SETAN NETWORK
O AN Network: Active
When AN Network is
set to "Active" or
"Basic," your TV can
perform automated
operations with other
Mitsubishi products.
Set to "OFF" if you do not have other
Active AN Network products or are not
using an AN Network control cable.
Use these buttons on the remote:
--_--] ADJUST [_ MENU to
to select go back
O
O
Press the MENU button on the
remote control. The Main Menu
will appear on the screen.
Use the ADJUST buttons to
select "First Time Setup." Press
the ENTER button.
Use the ADJUST buttons to
select "Set Arc" Network:." Press
the ENTER button.
Use the ADJUST buttons to
select "Active," "Basic," or "Off."
Check the rear terminals of
your VCR, then use the chart
below to determine how you
should set your Projection TV.
Press the ttOME button to
return to normal TV viewing.
If your VCR has a rear ...and you have set your ...then set your
terminal that reads: VCR to: TV to:
AN Network - Basic
Active A!V Network Off Basic
Active A!V Network Active Active
Does not have an A/V
Network rear terminal - Off
If you are not sure how to set your VCR's A/V Ne;work setting,
refer to your VCR's owner's guide.
32 Chapter 2: Operating Your Projection TV