Mitsubishi TS-4545 Owner's Manual page 44

Using the remote control to operate VCRs, cable
boxes and other components (cont.)
using your remote control to operate your cable box
Aider you have set up your remote control for your particular bra,
of cable box, you can use the remote to operaLe your cable box.
I[11 Use the select switch on the remote control to choose the layer
that you set up to operate your cable box: CABLE or VCR-B.
O Point the remote control at the cable box and press the desirec
buttons.
You can use the POWER, CHANNEL, numbers (0-9), and ENTER
buttons to operate, your cable box. If you
are
using an RCA DSS or
PRIMESTAR ®receiver, you may be able to use additional buttons,
setting up the remote control to operate your Mitsubishi
audio component (laserdisc player or A/V receiver)
10P Turn off your audio component.
Set the select switch on the top of the remote to choose the
layer you want to set up. For a laserdisc player, choose CABLE
or VCR-B. For an AJ7 receiver, or CD player, choose CABLE.
While holding in the POWER bu_ton on the remote control,
enter one of these code numbers:
• For a Mitsubishi AAr receiw_r, compact disc player: 30, 31 or 35
• For a Mitsubishi laserdisc player: 32 or 33
• For a Yamaha tW receiver, compact disc player: 36 or 37
Be sure to enter' both digits 0f the code number. If more than
one number is listed, try the first one.
O Release the POWER button.
O
Press the POWER button again. Your audio component should
turn on. If it does, your remote control is now set up to operate
your audio component. If it does not turn on, repeat the instruc-
tions above, trying the other code number listed for your
component.
(See "using your remote control to operate your Mitsubishi
laserdisc player" and "using your remote control to operate
your Mitsubishi audio products" in this chapter for information
on using the remote to operate ),our A/V comportments.)
44 Chapter 3: Operating Your TV