Table of Contents
Advertisement
10
When you want to end the call, press [End].
•
The Home screen is displayed.
Note
•
If the IP address contains 1 or 2 digit numbers, enter these numbers as they are. Do not enter like [.
001].
Example: The IP address is [192.168.0.1].
–
Correct entry: [192.168.0.1]
–
Wrong entry: [192.168.000.001]
•
To initiate a video conference call by entering a SIP URI (SIP user name@SIP domain name), you
must set "SIP Server" to "ON" and specify "SIP Server Address", "SIP Username", and "SIP
Domain Name". Also, specify "Digest Authentication", "Authentication ID", and "Authentication
Password" as necessary (Page 102). For details, contact your network administrator.
•
When making a video conference call within your own SIP domain, you can make the call by entering
the other party's SIP user name. When the other party is not within your SIP domain, you must also
include their SIP domain name in addition to their SIP user name.
When a SIP domain name is not specified, your own SIP domain name is automatically appended to
the address and the call is made. Be careful as this may result in calling the wrong party.
•
The characters that can be input for address entry are as follows:
SIP user name/H.323 name/MCU's conference room number: alphanumeric characters, symbols . =
* + _ - $
! ? / ' ( ) (up to 60 characters)
SIP domain name: alphanumeric characters, symbols . - (up to 128 characters)
H.323 extension: numeric characters, symbols # * (up to 20 characters)
Enter a standards-compliant value. For details, contact your network administrator.
•
To initiate a video conference call by entering an MCU's conference room number@IP address, "SIP
Server" and "Gatekeeper" must be set to "OFF" (Page 102, Page 104).
•
If the other party is using a software version older than 3.00 (not including 3.00), you cannot make a
video conference call using H.323. You must set "SIP" to "ON" on the call type settings screen
(Page 102).
•
You can refer to the contact list when entering the IP address, SIP URI (or SIP user name), H.323
extension, H.323 name, or MCU's conference room number@IP address, by following the procedure
below (You cannot enter a destination using the call history.):
1.
Press [G].
•
The contact list screen is displayed.
2.
Use [
][
•
You can use [
(Page 35).
3.
Press [Enter].
•
The display returns to the input screen.
] to select the contact you want to refer to.
][
] or the numeric buttons of the remote control to select the displayed tab
Starting a Video Conference
User Manual
37
Advertisement
Table of Contents
