Table of Contents
Advertisement
Additional Information
Message
Saving log failed.
System Error!
Please restart the system.
If error message appears
again, please contact Installer
or Service Administrator.
Miscellaneous
Problem
"Safe Mode" is displayed on
the screen.
Note
•
When "Safe Mode" is
displayed on the
screen, you cannot
connect to the
network, make video
conference calls, or
perform certain
settings (self
diagnosis, performing
a network test, etc.).
136
User Manual
•
You are using a USB memory device that is not compatible with the
unit.
→
Use a USB memory device compatible with the unit (Page 107).
•
There is not enough free space on the USB memory device you are
using.
→
Confirm the USB memory device has sufficient free space (at least
5 MB) before using it.
•
The unit's internal software failed to start up.
•
The unit failed to write data to the internal flash memory.
→
Reset the unit by turning off its power, then turning it back on. If the
same message is displayed after resetting the unit, contact your dealer.
•
A standard definition (640 ´ 480p, 720 ´ 480p) video camera signal has
been detected.
→
Disconnect the video camera from the unit, and reset the unit by turning
off its power, then turning it back on. Check to make sure the video
camera's resolution is set to HD (1920 ´ 1080i), and then connect the
video camera to the unit again.
A standard definition (640 ´ 480p, 720 ´ 480p) display signal has been
•
detected.
→
Disconnect the display from the unit, and reset the unit by turning off its
power, then turning it back on. Make sure to connect a HD (1920 ´
1080i) display to the unit.
•
The field frequency of the video camera or display you are using is
different from the field frequency setting of the unit.
→
Use a video camera or display that has the same field frequency as the
unit. For details, contact your dealer.
Cause and Solution
Cause and Solution
Advertisement
Table of Contents
