Table of Contents
Advertisement
Problem
Operation is unresponsive or
incorrect.
The remote control is
unresponsive.
•
Cables or cords may not be connected properly.
→
Check that all cables to the unit are connected properly (Page 16).
•
An error has occurred.
→
Turn off the unit and restart it.
•
There may be a problem with your communication lines.
→
Contact your dealer.
•
The batteries are depleted.
→
Replace with new batteries.
•
The remote control is being used out of the signal reception range.
→
Make sure to use the remote control within the signal reception range
(Page 15).
•
The remote control ID differs between the unit and the remote control.
→
Change the settings so that the remote control ID of the unit and the
remote control match. Perform the following procedure:
1.
Turn off the unit and restart it.
•
The Home screen is displayed. Check the remote control ID of
the unit (Page 27).
Note
•
If the remote control ID is not displayed on the Home
screen, contact your dealer.
2.
Press and hold [·] and [#] at the same time.
3.
Within 2 seconds after you release the buttons, press the number
(1 to 3) corresponding to the ID displayed on the Home screen.
Note
•
If the remote control is still unresponsive after performing
the procedure above, contact your dealer.
•
The FIX camera is set to receive remote control signals.
→
When using the remote control, be sure to point it at the remote control
signal receiver of the FIX camera.
→
Change the "FIX Cam's Remote Ctrl Rcvr" setting to
"OFF" (Page 97).
•
The unit is set to receive remote control signals.
→
When using the remote control, be sure to point it at the remote control
signal receiver of the unit (Page 15).
→
Change the "FIX Cam's Remote Ctrl Rcvr" setting to
"ON" (Page 97).
Cause and Solution
Additional Information
User Manual
123
Advertisement
Table of Contents
