Connecting And Disconnecting In Audio Interface Mode - Zoom R16 Operation Manual

Connecting and disconnecting in audio interface mode

This is a brief overview of connecting and disconnecting when a computer is hooked to the
R16 by USB cable. For details, please refer to the separately attached "Installation Guide."
Connecting the R16 to the computer
for the first time
1
Install Cubase LE 4 DAW
software on the computer
2
Download the latest ZOOM R16
audio driver from the ZOOM
website (see below).
3
Install the audio driver on the
computer.
Install/setup details
Reference: "USB/Cubase LE 4 Install Guide"
4
Connect the R16 to the computer.
R16 setup and connection
5
Setup DAW software
Control surface setup (Mackie Control) P.00
NOTE
The ZOOM R16 audio driver is essential for using
the R16 as an audio interface for DAW software
such as Cubase LE 4.
When downloading, follow the included instruction
guide to install correctly.
Please download the latest R16 audio
driver from Zoom Corporation's website
at (http://www.zoom.co.jp).
7
Device setup
R16 setup and connection
Follow these procedures from the second time connecting
1
2
Select
U S B
> A U D I O I N T E R F A C E
3
Verify.
A U D I O I N T E R F A C E
E n t e r ?
4
Select "Continue."
S E T T I N G ?
[ C O N T I N U E ] R E S E T
P.00
NOTE
• Set the recording quantization (bit depth) of
Cubase LE 4 or the DAW software that you are
using to 24-bit in order to achieve the best audio
quality when recording. (See the software manual
for how to make this setting.)
Press [USB].
>AUDIO INTERFACE
Press [Enter].
Press [Enter].
Press [Enter].
.
Change
menu
Change
menu