Table of Contents
Advertisement
•••• Config
••••• Ptl
••••• DS0 rate
••••• TxClk src
••••• TxClk invrsn
••••• Data invrsn
•••• Lp state
•••• Fixed access
• Maintenance
• System version
• Port/DN status
• Module status
• Sys test log
• Sys admin log
• Network evt log
• Provisioning
• Tests
• CSU stats
• Diagnostic tools
• Link Status
• Usage metrics
•• Hunt Groups
•• Call-by-Call
P0603536 02
Use to configure the settings for the SDI.
Select the physical interface used to connect the SDI to the networking
equipment.
Select the transmission rate of the channels (Fixed lines) assigned to the SDI.
Select whether data travelling through the SDI is synchronized using timing
(clocking) from the SDI or the DTE.
Invert the signal used by the SDI to synchronize data from the DTE to adjust
for round trip delays between the SDI and DTE.
Invert data travelling through the SDI before routing it to the T1 connection or
DTE to allow the SDI to support HDLC/SDLC (a transmission standard for
data) protocol.
Show the direction of the loopback, if any, generated by the SDI.
Assign fixed lines to supported data modules:
• IDM 200
• BayStack
• SDI).
These commands allow you to make diagnostic checks on the system.
Record the system version shown on the display.
View the Port/DN status.
View the Module status.
View items in Sys test log.
View items in log.
View the items in the Network Log.
This log keeps a record of events and alarms involving the digital network
interface.
Place BRI loops in or out of service.
Run and list any BERT-set tests.
View the performance statistics for your T1 lines.
Diagnostic tools programming performed by experienced personnel.
Use to gather statistical information about Hunt group usage.
Use to gather statistical information about PRI CbC calls.
105
Modular ICS 6.1 Programming Record
Advertisement
Table of Contents
