Nortel NORSTAR Modular ICS 6.1 Manual page 100

•• Sched:Night
••• Service
••• Trunk Answer
••• ExtraDial
••• Line settings
•••• Show line:_
••••• Ring grp
••••• Aux. ringer
•• Sched:Evening
•• Sched:Lunch
•• Sched:Sched 4
•• Sched:Sched 5
•• Sched:Sched 6
• Restrn service
•• Sched:Night
••• Service
•• Sched:Evening
•• Sched:Lunch
•• Sched:Sched 4
•• Sched:Sched 5
•• Sched:Sched 6
• Routing service
•• Routes
••• Show route:_
•••• DialOut
•••• Use
P0603536 02
Select options for your ringing service.
Select how you want your service activated.
Allow the telephone to answer incoming calls arriving at any telephone on the
system.
Enter the internal telephone number of the Extra-Dial telephone. This allows
you to assign an additional Direct-dial telephone in the Norstar system for
each schedule you use.
Select ringing service options for each line.
Enter the valid line number.
Press change to enter the line number of each pre-defined ring group
between 001 and 100.
Indicate whether the auxiliary ringer (if installed) also rings for this line when
Ringing service is on.
Enter the information for each of these settings as you have done for Night
sched.
Use these commands to select the method for activating alternate
restrictions.
Indicate how alternate call routing should be activated for each of the
schedules.
Select how you want your service activated.
Set up activation method for each of these settings, as you have with Night
sched.
A programming section that allows you to create up to 500 destination codes
and 999 routes to provide a dialing plan or for least cost routing.
Create the routes to be used when a destination code is dialed.
Enter the number of the route you want to create.
Enter the number, of up to 24 digits or characters, that you want this route to
dial out, if required.
Select the line pool you want this route to use.
91
Modular ICS 6.1 Programming Record