Nortel NORSTAR Modular ICS 6.1 Manual page 109

100
• Cells
•• Show cell:_
•• Cell radios
••• Show radio:_
•• Cell nghbrs
••• Show nghbr
•• Cell rad nghbrs
•• Show RadNghbr
• System LID
(MICS-XC systems, only)
• Rec'd # length
• DN length:_
• Nat'nl length
• Make/Break:
• BusName
• CbC limits
•• Pool PRI-A
••• Show: Public
•••• Min incoming
•••• Max incoming
•••• Min outgoing
•••• Max outgoing
• Release reasons
• Hospitality
•• Room/desk information
••• Show set:_
••• Room #:_
••• Adm pwd req'd:
Modular ICS 6.1 Programming Record
These commands provide information about the cells within the system.
Enter the number of the cell you wish to program.
Assign a radio to this cell.
Enter the number of the radio.
Assign a cell to be a neighbor. This is a cell that physically adjoins another
cell.
View neighbor information.
Assign a cell to be a bordering cell to each cell neighbour.
View cell radio neighbor information.
Use these commands to determine the System Access Logical Identifier (LID)
by which the system identifies itself to portable telephones, and by which the
portable telephones request service from the system.
Select the number of digits received on auto-answer lines.
These digits are used to identify the Auto DN and DISA DNs, and to route
calls to target lines.
Select the length of DNs.
DN length can be three to seven digits. Each increase in DN length adds the
digit 2 to an existing DN (for example: DN 344, when increased to five digits,
becomes 22344).
The length of the telephone number dialed to reach a person within the same
country.
Select the Make/Break ratio. The default Make/Break ratio is 40 / 60.
Enter the name of the business. This name displays on the receiving set,
where the line allows.
These commands allow you to program the minimum and maximum incoming
and outgoing calls for a PRI line pool.
Select the PRI line pool (PRI-A, PRI-B....) for which you want to set the limits.
Select Public or Private, or Tie, FX, OUTWATS, 800
Enter the minimum number of incoming PRI lines you need.
Enter the maximum number of incoming PRI lines you need.
Enter the minimum number of outgoing PRI lines you need.
Enter the maximum number of outgoing PRI lines you need.
Release reasons.
These commands allow you to create the hospitality settings.
These commands allow you to assign sets to a room.
Indicate the set you wish to configure.
Indicate the room associated with the set.
Indicate whether the set requires the use of the Hospitality Desk Admin
password to access Hospitality Desk features.
P0603536 02