Optional Hearth Trim Installation - Regency Sunrise E33S-NG1 Owners & Installation Manual

The Hearth Trim is an option that can be used to fi nish off the installation when the bottom of the fi replace is higher
than the hearth or to raise the fi replace. The faceplate is assembled fi rst and then the hearth trim is attached to the
faceplate. There are 2 Hearth Trim options; a 2" and a 4".
2" Hearth Trim (341-942) Installation:
1) Attach the Hearth Trim to the bottom of the faceplate side
panels with the screws provided (3 per side) as shown in
diagram 1. The holes in the Hearth Trim are oblong so the
trim can be adjusted inwards or outwards as needed to suit
fi nishing.
NOTE: Don't tighten the screws down completely at this point,
do a trial fi t to the unit, make any necessary adjustments and
when it fi ts properly then tighten screws.
Diagram 1
®
Regency E33S-1 Sunrise Gas Insert
OPTIONAL HEARTH TRIM
INSTALLATION
1) Secure the two 2" hearth trim pieces together as shown in
diagram 2. Secure using the 2 screws provided.
2) Attach the now 4" Hearth Trim to the bottom of the faceplate
side panels with the screws provided (3 per side) as shown
in diagram 1. The holes in the Hearth Trim are oblong so
the trim can be adjusted inwards or outwards as needed to
suit fi nishing.
4" Hearth Trim (341-944) Installation:
Diagram 2
INSTALLATION
27