INSTALLATION
6) Remove the left and right side inner panels by removing the clip that
holds the panels in place. Left side panel clip shown.
Note: Screw does not need to be completely removed, only loosened.
7) Remove the back panel by lifting up and slide out carefully.
Note: The removed standard panels may be discarded.
Installation of Black Enamel or Stainless Steel Panels
8) Loosen the 2 end screws + 1 centre screw securing the heat defl ector.
Slide the top refl ective panel in place over top of the heat defl ector.
9) Secure top panel using 2 screws at the back - then tighten the 3
screws at the front
20
10) After the top panel has been secured - install the back panel. The
back panel is held in place by the side panels
11) Install the left side panel - secure in place one screw and a panel
clip.
:
®
Regency
E33S-1 Sunrise Gas Insert