Optional Refl Ective Panel Installation - Regency Sunrise E33S-NG1 Owners & Installation Manual

E33 sunrise gas insert
Hide thumbs Also See for Sunrise E33S-NG1:
Table of Contents

Advertisement

OPTIONAL REFLECTIVE PANEL INSTALLATION
Before installation, panels must be handled and cleaned as per instructions noted below:
Stainless Steel Panels
Stainless panels must be inspected for scratches and dimples prior
to installation. All claims to be recorded at this time. Claims for dam-
age after installation will not receive consideration.
To protect the fi nish during installation and handling - cotton
gloves MUST be worn at all times while handling the panels (even when
removing protective coating).
Use a hair dryer to remove the protective coating from the panels.
Stainless panels will discolor a little during normal operation.
This is normal and should not be considered a defect.
*
All hand and fi nger marks MUST be cleaned off with a soft cloth and
a stainless steel cleaner. Most stainless steel cleaners leave a fi lm/
residue on the surface of the panels. Use an ammonia based cleaner
(ie. glass cleaner) to remove this fi lm before applying heat to the unit.
Failure to do this will result in burn stains on panels which you
will be unable to remove. Not protected by product warranty.
Removal of Standard Black Panels already in Unit:
1) Turn off power and gas supply.
2) Remove louvers and fl ush door.
3) Remove the burner by undoing the 2 screws that secure it in place.
Carefully lift the burner up and out, ensuring not to spill the glass
crystals.
Burner
®
Regency
E33S-1 Sunrise Gas Insert
Black Enamel Panels
Black Enamel panels must be inspected for scratches and dimples
prior to installation. All claims to be recorded at this time. Claims for
damage after installation will not receive consideration.
Black Enamel panels will discolor a little during normal operation.
This is normal and should not be considered a defect.
*
All hand and fi nger marks MUST be cleaned off with a soft cloth. Use
an ammonia based cleaner (ie. glass cleaner) to remove any fi ngerprints
before applying heat to the unit.
Failure to do this will result in burn stain on panels which you
will be unable to remove. Not protected by product warranty.
4) Remove the pilot assembly cover by removing the 2 screws as shown
in the image below.
Pilot Assembly Cover
5) Remove the fi rebox base by lifting up from the back and maneuver
out carefully. Ensure not to scratch the paint work or damage the
pilot while lifting out.
Firebox Base
INSTALLATION
19

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sunrise e33s-lp1

Table of Contents