Regency Sunrise E33S-NG1 Owners & Installation Manual page 16

INSTALLATION
7) Install the 1/2" bushing to the heat
shield.
8) Run the other end of the ground wire
and DC spark generator wires through
the bushing on the heat shield.
Heat Shield
9) Plug the DC spark generator wires to the
DC Sparker.
10) Connect the ground wire to the DC
Sparker mounting bracket.
16
11) Install the supplied battery into the DC
Sparker Box by opening the battery
compartment.
NOTE: The battery in the DC Sparker
Box will need to be replaced annually.
Battery
Compartment
12) Mount the heat shield to the DC Sparker.
Secure into place with the velcro, which
is provided in the kit.
13) Find a location which is not too hot and
is easy to reach for changing the battery.
See image below as an example.
Note: It should be kept away from the
chain (U32S only).
14) Tie up the loose wire with the wire clip.
15) Check for gas leaks with a proper soapy
solution or leak detector.
16) Check for proper spark between the
ignitor and pilot cap. Refer to "Lighting
Procedure" section of the manual for
lighting sequence.
17) Check inlet (12" WC min) and outlet
(11" WC) pressures. Refer to "Gas Pipe
Pressure Testing" section of the manual.
18) Check for proper fl ame appearance.
Installer Notice:
These instructions must be left
with the appliance.
Chain
®
Regency E33S-1 Sunrise Gas Insert