Optional Hearth Trim Installation - Regency Sunrise U32SE-NG5 Owners & Installation Manual

INSTALLATION
The Hearth Trim is an option that can be used to fi nish off the installation when the bottom of the fi replace is higher
than the hearth or to raise the fi replace. The faceplate is assembled fi rst and then the hearth trim is attached to the
faceplate. There are 2 Hearth Trim options; a 2" and a 4".
2" Hearth Trim Installation:
1) Attach the Hearth Trim to the bottom of the faceplate side
panels with the screws provided (3 per side) as shown in
diagram 1. The holes in the Hearth Trim are oblong so the
trim can be adjusted inwards or outwards as needed to suit
fi nishing.
NOTE: Don't tighten the screws down completely at this point,
do a trial fi t to the unit, make any necessary adjustments,
when trim fi ts properly, tighten the screws.
28

OPTIONAL HEARTH TRIM INSTALLATION

Diagram 1
4" Hearth Trim Installation:
1) Secure the two 2" hearth trim pieces together as shown in
diagram 2. Secure using the 2 screws provided.
2) Attach the now 4" Hearth Trim to the bottom of the faceplate
side panels with the screws provided (3 per side) as shown
in diagram 1. The holes in the Hearth Trim are oblong so
the trim can be adjusted inwards or outwards as needed to
suit fi nishing.
Diagram 2
U32SE-5 FPI Direct Vent Gas Insert