Optional Remote Control; Optional Wall Thermostat - Regency Sunrise E33S-NG1 Owners & Installation Manual

INSTALLATION
For
*For installation of the DC Spark Box refer to the LP Conversion instructions in this manual.
OPTIONAL REMOTE
CONTROL
Use the FPI Remote Control Kit approved for
this unit. Use of other systems may void your
warranty.
The remote control kit comes with a hand held
transmitter, a receiver and a wall mounting
plate.
1) Choose a convenient location on the wall
to install the receiver and the receptacle
box (protection from extreme heat is very
important). Run wires from the fi replace to
that location. Use Thermostat Wire Table.
2) Connect the wires as per the wiring diagrams
below.
CAUTION
Do not connect the millivolt
remote control wires
to the 120V wires.
18
PROPANE
Units and Units Equipped with DC Spark Boxes*
3) Install 3 AAA alkaline batteries in transmitter
and 4 AA alkaline batteries in the receiver.
Install the receiver and its cover in the wall.
Switch the remote receiver to "remote"
mode. The remote control is now ready
for operation. Refer to Remote manual for
complete details.
OPTIONAL WALL
A wall thermostat may be installed if desired,
follow the wiring diagram. Note: the wires are
connected to the "TH" on the gas valve. Use
the table below to determine the maximum wire
length. FPI offers an optional programmable
thermostat but any 250-750 millivolt rated non-
anticipator type thermostat that is CSA, ULC or
UL approved may be used.
THERMOSTAT
It is recommended that the thermostat be
installed on an interior wall.
CAUTION
Do not connect the millivolt
wall thermostat wires
to the 120V wires.
Thermostat Wire Table
Recommended Maximum Lead Length
(Two-Wire) When Using Wall
Thermostat (CP-2 System)
Wire Size Max. Length
14 GA.
16 GA.
18 GA.
20 GA.
22 GA.
®
Regency E33S-1 Sunrise Gas Insert
50 Ft.
32 Ft.
20 Ft.
12 Ft.
9 Ft.