Conversion From Ng To Lp - Regency Sunrise E33S-NG1 Owners & Installation Manual

THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER
NOTE: See page 1 for H25 / H27 conversion instructions and page 4 for P33S-4 conversion instructions.
Each Kit contains one LP
Conversion Kit and one DC
Sparker Kit.
LP Conversion Kit Contains:
Qty. Part # Description
1 904-163 Burner Orifi ce #54
1 918-590 Decal "Converted to
LPG"
1 908-528 Red "LPG" label
1 904-529 5/32" Allen Key
1 910-037 LPG Injector
(Pilot Orifi ce)
1 918-480 Instruction Sheet
DC Sparker Kit Contains:
Qty. Part # Description
1 820-475 Bracket DC Sparker
1 820-476 Bracket DC Sparker
1 904-153 Washer #8 External Star
1 904-330 Nut 8-32 Hex
1 904-438 Plug Nylon 0.750 Hole,
Black (for H25 only)
1 904-531 Bushing Split Plastic
0.500 in.
1 904-543 Screw 8-32 x 3/4 Pan
Head
2 904-553 Screw #8 x 1/2 Type
"B", Black Oxide
1 910-073 Spark Generator
Battery Holder
1 910-074 Spark Generator
Switch C/W Wire
1 910-078 Battery Size AA
Energizer En91
2 910-199 Clip Wire Holder
1 910-903 Wire Fan To Power Cord
Ground 30 in.
904-781 Velcro Hook, Black
904-782 Velcro Hook, Black
1) Turn off the gas supply.
2) Remove the glass door.
E33S only:
a) Remove the 2 screws at the bottom
of the glass door.
®
Regency E33S-1 Sunrise Gas Insert
CONVERSION KIT #434-969 FROM NG TO LP
IF IN DOUBT DO NOT DO THIS CONVERSION!!
U32S only:
a) Release the two hooks from the
bottom of the glass door.
b) Swing the door out 45 degrees from
the bottom and lift up and out (applies
to both units).
3) Remove the burner by undoing the 2
screws as shown below.
Burner
Burner screws on E33S
INSTALLATION
Burner screws on U32S
4) After screws have been removed,
slide the burner to the left, then lift out
carefully (U32S unit only.)
(E33S - lift burner directly out).
U32S burner shown
5) Remove the pilot shield by removing the
2 screws as shown below.
6) Remove the base cover by lifting up
from the back and maneover out.
Base Cover
13