Miter Lock Assembly - Craftsman 113.234701 Owner's Manual

Assembly
2. Place table so that larger holes face
up. Align table over middle and front
holes in table supports. Note: Table will
extend over front edge of frame.
3. Drop flat washer into each hole, then
insert screw. From underneath surface,
on end of each screw put lock washer,
then nut. Hold in place and tighten with
screw driver.
®
Larger
Opening
Up
Miter Lock Assembly
The miter lock is factory assembled, but
it may need adjustment. Follow these
steps to see if adjustment is needed and
how to make adjustment.
1. Pull out miter index pin and turn 90 °
to lock out.
2. Unlock miter lock. It should feel loose
when unlocked. Move radial arm to right
and left, through miter range. It should
move freely.
3. Lock miter lock. It should feel tight
when locked. Try to move radial arm
through miter range. It should not
move.
4. If step 3 is not met, remove screw and
nut retainer. Tighten nut as needed.
Replace nut retainer and screw. Repeat
steps 2, 3, and 4 until lock is adjusted.
5. Turn miter index pin 90 ° to allow it to
engage 0 ° indexed position. Rotate
miter scale to line up 0 with arrow.
Miter Index
Miter Lock
0 Mark
22