Assembly
2. Position base so that edge is off work
surface.
3. From inside surface,
put carriage
bolt
through
slot in base and hold in place at
highest point.
4. Slide side frame
into place on base so
that table clamp screw mount
fits into
notch on side frame.
5. On end of bolt put flat washer,
then
lock washer, then nut and finger tighten.
Note: Later in assembly, these will be
wrench tightened.
6. Repeat for other slot of base.
7. Repeat
for other side frame.
Notch
Table Clamp
Screw Mount
8. Set out:
-front stiffener
,four truss head bolts 5/16 '' diameter
by s_"
-four s'16"diameter
flat washers
-four 5/16"diameter
lock washers
-four s'16"diameter
nuts.
9. Place front stiffener
between
side
frames so that tabs of stiffener
stay on
inside of side frames.
10. Put bolt through
hole in front stif-
fener tab and through
side frame.
11. On end of bolt put flat washer,
then
lock washer,
then nut and wrench
tighten.
12. Repeat
for other 3 holes.
_
5/16"
Hex Nut
5/16" x 5/8"
5/16"
_
_
,)
_
Truss Head Bolt
Lock Washer
Side
Frame
5116"
\
Flat
Washer
Front
Stiffener
15