Front Table - Craftsman 113.234701 Owner's Manual

Assembly
2. Place table support against side frame
so that rectangular openings line up
with square openings in side frame, and
narrow edge is on top and outside.
3. Put bolt through square opening in
side frame from inside surface.
4. On end of bolt put flat washer, then
lock washer, then nut and finger tighten.
Note: Later, in alignment, these will be
wrench tightened.
5. Repeat for other opening.
6. Repeat for other table support.
Table Suppo_
Side Frame
FrontTable Assembly
1. Set out:
-front table
-four phillips pan head screws v'4"
diameter by 1"
-four 1/4"diameter flat washers
-four 1/4"diameter lock washers
-four 1/4"diameter nuts.
1/4" x 1" Phillips
Pan Head Screw
1/4"
Flat Washer
Q Q
1/4" 1/4" Hex Nut
Lock Washer
21