Table of Contents
Advertisement
Safety
Blade Safety Instructions
1. Use only blades marked for at least
5500 rpm.
2. Use only blades 81/4 inches in
diameter.
3. Use blades for their recommended
cutting procedures.
4. Keep blade sharp and clean.
5. Do not overtighten
nut when securing
blade to saw because
blade collar could
warp.
6. Do not turn saw on and off in rapid se-
quence because blade can loosen.
7. Blade
should
stop within
15 seconds
after saw is switched
"off".
If blade
takes
longer
than
15 seconds
to stop, the motor
needs
repair.
Contact
Sears
Service
Cen-
ter.
On-Product
Safety Labels
There
are several
safety labels on the
saw. They alert the user to hazards
ex-
plained
in the manual
and remind
the
user how to avoid the hazard.
Note where they are located on the saw.
Read and follow the safety information
and instructions
in these labels. Refer
to themanual
for detailed explanations
and instructions.
On the outfeed
side of the guard
are
these
two safety
labels
to alert you
to
wrong
way feed:
DANGERM
TO AVOID
INJURY
DO NOT
FEED MATERIAL
INTO CUTTING
TOOL FROM
THIS END
Hide quick links:
Advertisement
Table of Contents
