Assembly
7. Lift front end of radial arm and slide
front table between
radial arm and
frame, towards
front. Do not let table
edges rest in notches
of side frame.
8. Leave
front table in place. Wrench
tighten
rear bolt on each side where
side frame
attaches
to base.
9. Further
tighten
front bolt.
10. Remove
front table.
11. Check that distance
between
radial
arm and frame
is approximately
same at
front and rear. Re-adjust
if necessary.
Rear
Bolt
Front
Bolt
Table Support
Assembly
1. Set out:
-two table supports
-four carriage
bolts s/16"diameter
by v'2"
-four s/16"diameter
flat washers
-four 5/16"diameter
lock washers
-four s/16"diameter
nuts.
5/16" x 1/2"
Carriage
Bolt
5/1 6"
Flat Washer
5/16"
Lock
Washer
Table Support
Q
5116" Hex
Nut
2O