Quick-Cam Miter Table Lock Adjustment; Table Support Rod Adjustment; Turning Laser Guide On; Aligning The Laser Guide - Craftsman 137.407530 Operator's Manual

Setting the cutting depth (Fig. %1):
The depth of cut can be preset for even
and repetitive shallow cuts.
1. Adjust the cutting head down until
the teeth of the blade are at the
desired depth.
2. While holding the upper arm in that
position, turn the stop knob (1) until
it touches the stop plate (2).
3. Recheck the blade depth by moving
the cutting head front to back
through the full motion of a typical
cut along the control arm.
QUICK-CAM MITER TABLE LOCK
ADJUSTMENT (FIG. U)
1. Press down and lock the quick-cam
miter table lock (1).
2. If the table moves with the quick-
cam miter table lock in the down
position, turn the stop nut (2) to
the left as shown using a 13 mm
wrench to extend the locking arm
against the base of the miter saw.
3. Test the quick cam miter lock to
verify it locks the table into position
securely.
4. Turn the lock nut (3) to the right
as shown to lock the miter locking
mechanism into place.
Fig. U 2
/1
4 _---- 5
TABLE SUPPORT ROD ADJUSTMENT
(FIG. U)
1. Put the miter saw on a fiat surface.
2. Check the miter saw whether the
miter saw is level with the fiat surface.
3. If not, loosen the nut (4) and turn
the table support rod (5) clockwise
or anti-clockwise to adjust the
height of the table support rod (5)
until the miter saw is level with the
fiat surface.
4. Tighten the nut (4).
TURNING LASER GUIDE ON (FIG. V)
1. To turn laser on, press on/off rocker
switch (1) to "ON" position.
2. To turn laser off, press on/off rocker
switch to "OFF" position.
Fig. V 1
ALiGNiNG THE LASER GUIDE
The laser beam must always be
correctly aligned with the blade to
ensure straight, even cutting. Your
tool is equipped with the Laser Guide
cutting guide using Class Ilia laser
beam. The laser beam will enable you
to preview the saw blade path on the
stock to be cut before starting the miter
saw. This laser guide is powered by the
transformed alternating current supply
directly through the power lead. The
saw must be connected to the power
source and the laser on/off switch
must be turned on for the laser line
to show.