Craftsman 113.234701 Owner's Manual page 76

TroubleshoOting
Saw Problem
Blade carriage does not
travel smoothly on arm
Possible Cause(s)
Dirty track
Bad bearing
Bearing set too tight
Worn arm track
Rip lock too tight
What to Do
Clean track
Replace bearing
See Adjustment, Carriage
Bearings
Replace radial arm
See Adjustment, Rip Lock
Table cannot be leveled Base has shifted on frame Remove front table.
Loosen four bolts thaf hold
base to frame. Follow steps
under Making Radial Arm
Parallel to Frame in As-
sembly section. Then re-
align saw
Blade does not stop spin-
ning within 15 seconds after
saw is turned off
Blade nut loose
Internal damage
Tighten blade nut
Take saw back to Sears for
service
76