Craftsman 113.234701 Owner's Manual page 23

Assembly
Install Rip Scale Indicators, Table
Clamp Screws, and Dust Elbow
1. Set out:
-two rip scale indicators
-two table clamp screws
-two table clamp washers
-dust elbow.
2. Snap one indicator onto each side of
blade carriage.
3. From rear, screw table clamp screws
through holes in table clamp mounts,
until screw protrudes enough to tap on
washer. Note: Concave side of washer
faces table edge.
i_"_ Rip Scale
Indicator
Table Clamp
Screw
/
Radial Arm
/
Blade
Carriage
Table Clamp
Screw Mount
Table Clamp
Washer
4. Push dust elbow onto opening on top
of guard.
You cannot use the saw until it is
aligned. Go to Alignment and Adjust-
ment Section and follow all instruc-
tions. It may be helpful to read the
Controls Section before proceeding
with alignment and adjustment.
Dust Elbow
23