Radial Arm To Base Assembly - Craftsman 113.234701 Owner's Manual

Assembly
Radial Arm to Base Assembly
1. Remove column retaining screw from
base enough so column can clear when
inserted.
2. Unlock miter lock. Pull out miter
index pin and turn 90 ° to lock out.
3. Get grease packet. Being careful of
sharp edges which may be present in
base opening, evenly spread grease
around inside of base opening. Notice
shoulder at bottom of base.
Unlock
IndMeitxepin"_-_"_ _--i
"-4
Miter
Lock
€
\ ,
Column
Retaining
Screw
4. Insert column into base opening,
pushing down until column goes all the
way down to rest on shoulder at bottom
of base.
5. Use a wrench to re-install column
retaining screw and tighten securely.
6. Turn miter index pin 90° to allow it to
engage indexed position.
7. Lock miter lock.
18