Craftsman 113.234701 Owner's Manual page 58

Ripping
Kerfs
A kerf or shallow cut is needed in the
table to serve as a path for the blade
and to ensure that the blade cuts all the
way through the workpiece. A kerf is
needed for each different cutting posi-
tion.
Follow these steps to make a kerf:
1. Check that saw is unplugged, switch is
"off', and yellow key is out.
2. Put solid (no kerfs) fence in desired
position and tighten table clamps.
3. Index arm to 0° miter position. Lock
miter lock.
4. Set desired bevel angle and lock
bevel lock.
5. Unlock swivel lock, press and hold
swivel index pin and set blade to rip
position. Release swivel index pin, and
lock swivel lock.
Swivel
Swivel Lock
=====_,
58