Setting the Remote Code
The remote code prevents unauthorized people from accessing your unit
and listening to your messages. Choose any 2-digit number
(00-99).
The factory preset remote code is "11". If you do not program your own
remote code, you can use "11".
Make sure that the unit is in the stand-by mode.
1
2
3
4
5
6
Press [FUNCTION/EDIT).
>Redial
Directory
v^
0K:Yes
Ringer
volume
_Program
v^
0K:Yes
_Save
directory
Set
flash
time
v^
OK:Yes
Talk
switching
_TAD
program
v^
0K:Yes
Answering
system
setting
(111]
Press {_ or {_ repeatedly until the arrow
pointsto"grogram".
Press OK _
(Yes
key).
Press [_ or (_ repeatedly untit the arrow
points
to "TAD program".
Press OK [_
(Yes
key).
• "P" is disprayed on the base unit.
Press {!).
• The current remote code is displayed on the base unit.
Enter a remote code using a 2-digit number
(00-99).
• The entered number is displayed on the base unit.
8
Press OKra.
• A beep sounds.
• The display willreturnto
step 4. To return tethe stand-by mode,
press_or
waitfor60
seconds.
• If 6 beeps sound during programming,
a wrong key was pressed. Enter
the correct number.
To check the remote code
Repeat steps 1 to 6.
• The current remote code is displayed on the base unit. When finished,
press _.