Panasonic KX-TG2570F Operating Instructions Manual page 77

Answering system
Problem
The answering system is on,
but incoming messages are
not recorded,
Remedy
• The recording time is set to "greeting
only". Select "1 minute" or "3 minutes"
(p. 26).
• Memory is full. Erase some or all of the
messages (p. 57).
You cannot listen to the
recorded messages.
"_" is displayed and the
ANSWER ON indicator
flashes rapidly, and no new
messages are recorded.
• Make sure that the unit is in the stand-
by mode.
• Memory is full. Erase some or all of the
messages (p. 57).
You cannot operate the
answering system at the base
unit.
• The handset user is operating the
answering system or is engaged in an
outside call. Wait until the
IN USE/CHARGE indicator light goes
out.
You cannot operate the
answering system from a
touch tone phone.
• Make sure you enter the correct remote
code.
• The answering system may not
respond if the tones are too short to
activate the unit. Press each button
firmly.
• The answering system is off. Turn it on
(p. 69).
You cannot operate the
answering system with the
handset.
• Someone is operating the answering
system.
• You are too far from the base unit.
Move closer to the base unit.
• The unit is recording a message.
To answer the call, press _).