Storing Your Area Code
We recommend that you first program your area code before using the
Caller ID feature (p. 32). Incoming calls from the same area code will then
be recorded in the Caller List without the area code. You do not have to
remove the area code before calling back or storing. When incoming calls
from a different area code are received, "1" will automatically
be added
before the area code.
Make sure that the unit is in the stand-by mode.
Press [FUNCTION/EDIT].
Press _
or [_ repeatedly until the arrow
points to "Program",
Press OK [_ (Yes key).
Ringer
volume
_Program
v^
OK-Yes
_Area code
2nd area code
VA
OK-Yes
Area code
Enter area code
Area code
:123
OK-Save
Area code
:123
Press [_
or [_
repeatedly until the arrow
points to "Area
code".
Press OK [_[]
(Yes
key).
• The current setting is displayed. If no area
code has been stored, "---"
will be
displayed.
Enter your area code.
• If you enter a wrong number, press BACK
[_] and enter the correct number.
Press OK [_
(Yes
key).
• A beep sounds.
• The display will return to step 4. To return
to the stand-by mode, press _
or
wait for 60 seconds.
To erase the area code
Press BACK [_[] in step 6.
• If a "2nd area code" has been stored (p. 18), it will also be erased
automatically.
• You can exit the programming mode any time by pressing _.