Assembly - Weider Platinum XP800 User Manual

ASSEMBLY
Make Things Easier for Yourself
This manual is designed to ensure that the resist-
ance system can be assembled successfully by
most people. However. it is important to realize
that th6 versatile resistance system has many
parts and that the assembly process will take
time, Most people find that by setting aside plenty
of time. assembly wiii go smoothly.
Before beginning assembly, carefully read the
following information and instructions:
Assembly requires two persons,
Place all parts in a cleared area and remove the
packing materials, Do not dispose of the packing
materials until assembly is completed,
For he@ identifying small parts, use the PART
IDENTIFICATION CHART. Note: Some small
parts may have been pre-attached for shipping, if
a part is not in the parts bag, check to see if it
has been pre-attached,
• Tighten all parts as you assemble them, unless
instructed to do otherwise,
As you assemble the resistance system, make
sure all parts are oriented as shown in the draw-
ings,
H
The included Alien wrenches W _ and the foF
lowing toots (not included) are required for
assembly:
• Two adjustable wrenches
One rubber maitet
* One standard screwdriver _L_
* One Philtips screwdriver __-_D
• Lubricant, such as grease or petroleum jelly,
and soapy water.
Assembly wiii be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches,
t,
Before beginning assembJy, make sure that
you have read and understand the informa_
tion in the box above. Refe[ to the PART
iDENTiFiCATiON CHART for help !dent!fy!ng
small parts.
Pull the lower end of the Upper Wire Harness
(71) out of the hob in the back of the Upright (2),
Attach the Upright (2) to the Base Hate (1) with
an MIO x 25mm Button Screw (88), an MIO
Washer (106), an MIO x 92mm Button Bolt (83),
and an MIO Nylon Locknut (103),
71
88
6