Troubleshoothng - Weider Platinum XP800 User Manual

RECAUBRATmNG THE CONSOLE
To recaHbrate the ConsoUe (67), first pUugin the resist°
ance system (see PLUGGUNG UNTHE RESISTANCE
SYSTEM on page 16). Then, press and hoUdthe
NEXT button and the MOTORUZED WEUGHT
ADJUSTMENT + button for five seconds. When the
buttons are reUeased, a number wHU appear in the
REPS dispUay. Press the NEXT button again, then
press the MOTORUZED WEUGHT ADJUSTMENT +
button; this wHU start the recaHbration process. This
may take a few minutes as the motor moves between
the Uowest and highest resistance settings. When the
motor finishes, unpUug the transformer from the 120-
voUtoutlet.
The ConsoUe (67) wHU be recaHbrated. Use the resist°
ance system as described in the CONSOLE OPERA-
TUON section, starting on page 16.
CLEANING THE BAR GUIDES
Over time, dust may build up on the Crossbar Guides
(15), causing a squeaking noise as the resistance
system is used. If this occurs, wipe off the Crossbar
Guides with a damp cloth and a mild, nonoabrasive
detergent. Do not use solvents.
ADJUSTING THE RESISTANCE
When the resistance setting changes, the motor will
be heard. To prevent damage to the motor, do not
pull any of the cabJes while the resistance setting
is changing. If a cable is pulled, the words
RELEASE HANDLES AND READJUST RESIST°
ANCE AS DESIRED may appear in the main display
on the console.
If this message is displayed repeatedly but no cable
is being pulled, there may be too much tension on the
upper cable (A). Adjust the tension as described
below.
To decrease the tension on the upper cable (A), turn
the two 3/8" x 38mm Tension Screws (114) twice,
counterclockwise. Select the desired resistance set°
ting. Repeat this step if necessary.
/
A
19