Weider Platinum XP800 User Manual page 8

5. 5
6,
7,
insert the Squat Pin (66) into the Upright (2).
SHde the Squat Carriage (19) onto the Upright (2).
Attach the Top Frame (37) to the Upright (2) with
two MIO x 25mm Button Screws (88), an MIO x
75mm Button Screw (84), three MIO Lock
Washers (75), and an MIO Washer (106).
Pull the excess Upper Wire Harness (71) out of
the Upright (2). insert the connector on the
Consob (67) into the socket on the Upper Wire
Harness. The connector shoutd slide easily into
the socket and snap into place, if the connector
does not slide easily and snap into pUace,turn the
connector over and then insert it.
Make sure that the connector and wires appear
as shown in the inset drawing. IF THE CONNEC-
TOR IS NOT INSERTED PROPERLY, THE CON-
SOLE MAY BE DAMAGED WHEN THE POWER
mSTURNED ON.
Push the excess Upper Wire Harness (71) into
the Upright (2).
Attach the Consob (67) to the Upright (2) with
four M4 x 70mm Screws (53).
19
66
88
75
106
53
84
Red
Wire
8