Weider Platinum XP800 User Manual page 10

11, insert the Resistance Bar (9) between the
Crossbar Guides (15), and center it on the
Crossbar Block (not shown),
Press a Pulley Bracket (10) onto the Resistance
Bar (9), Screw a 3/8" x 38mm Tension Screw
(114) into the Pulley Bracket a couple of turns,
Make sure the hexagonal hoJe in the Screw is
on the outside of the Bracket.
Attach a Tether (70) to the Pulley Bracket (10) at
the upper hole, with an MI0 x 64mm Button Bolt
(80), an M10 Thick Washer (54), and an MI0 Nylon
Locknut (103).
Repeat on the other side of the Resistance
Bar (9}. Then, tighten the lower M1O x 152mm
Bolt (86} used in step 10.
12, Hold a Large Pulley (14) inside the Upper Cable
(121), Attach the Pulley to a Pulley Bracket (10)
with an M12 x 58mm Button Bolt (87) and an M12
Nylon Locknut (13), Make sure that the CabJe is
routed as shown in the CABLE DIAGRAM on
page 18.
13, Hold a Large Pulley (14) inside the Upper Cable
(121), Attach the Pulley to the other Pulley
Bracket (10) with an M12 x 58mm Button Bolt
(87) and an M12 Nylon Locknut (13), Make sure
that the Cable is routed as shown in the
CABLE DIAGRAM on page 18.
Tighten the two 3/8" x 38ram Tension Screws
(114} an equal number of turns.
14, Attach the Leg Lever (56) to the Leg (5) with a
Leg Station Pin (60), Slide a Cotter Pin (113) onto
the Leg Station Pin,
11
12
14
10
87_
7O
13
121
87
13
114
10
/
114
6O
10