Adjustments - Weider Platinum XP800 User Manual

ADJUSTMENTS
This section expUains how to adjust the resistance system, See the EXERCUSE GUUDEUNES on page 20 for
important information about how to get the most benefit from your exercise program, AUso, refer to the accompa-
nying exercise guide to see the correct form for each exercise,
Make sure aH parts are properUy tightened each time the resistance system is used, RepUace worn parts immedi-
ateUy,The resistance system can be cleaned with a damp cUothand a mild, non-abrasive detergent, Do not use
soUvents, The resistance bar can be cleaned with a vinyUand rubber protectant, avaHaMe at an automotive or
department store,
ATTACHING THE HIGH PULLEYS
To use a high pulley, slide the hook on the Pulley
Housing (39) onto an hook on the Top Frame (37),
Attach the end of the High CaMe (101) without the
bah to the end of the Lower CaMe (120) with a CaMe
CHp (94), Attach the other high pulley in the same
manner.
Remove the high putteys when not in use.
USING THE LEG LEVER
To use the Leg Lever (56), attach it to the Leg (5) with
a Leg Station Pin (60), Slide a Cotter Pin (113) onto
the Leg Station Pin,
Route the hook end of the Leg Lever Cable (102)
under the 90mm Pulley (40) in the Leg (5), and attach
it to the Leg Lever (56), Make sure the hook is ori-
ented as shown when attaching it to the Leg
Lever. Insert a Leg Station Pin (60) into the Leg,
under the Cable, Slide a Cotter Pin (113) onto the Leg
Station Pin,
See the inset drawing. Attach a long end of the Leg
Lever Cable (102) to one end of the Lower Cable
(120) with a Cable Clip (94), Attach the other tong
end of the Leg Lever Cable to the other end of the
tow cable in the same manner.
102
120 /
94
120
113
6O
13