Weider Platinum XP800 User Manual page 9

8, 8
Attach a Large Pulley (14) and the Pulley Hate
(68) to the Upright (2) with an M12 x 62mm
Button BoUt(81) and an M12 NyUonLocknut (13),
Do not tighten the Locknut yet.
9,
Pull the Upper CaMe (121), which is attached
inside of the Mech Frame (not shown), up
between the Upright (2) and the Pulley Hate (68),
Attach another Large Pulley (14) to the Upright (2)
and Pulley Hate (68) with an M12 x 62mm Button
BoUt(81) and an M12 NyUonLocknut (13), Make
sure that the Upper Cable (!21} is between the
two Pulleys.
HoUdthe 38mm Spacer (90) inside the Uoopof the
Upper CaMe (121), and between the Upright (2)
and the Pulley Hate (68), Attach the Spacer with
an MIO x 58mm Button Screw (11), Make sure
the ends of the Cable do not wrap around
each other below the Spacer and the Large
Pulleys (14} used in steps 8 and 9 (refer to the
CABLE DIAGRAM on page 18}.
Tighten the M!2 Nylon Locknuts (13} used in
steps 8 and 9.
10, Attach a Small Guide Spacer (18), a Large Guide
Spacer (17), and two Crossbar Guides (15) to the
Upright (2) with an MIO x 152mm Bolt (86),
Pull the Upper Cable (121) up between the
Crossbar Guides (15), Press the metal cover on
the Cable into the groove in the Crossbar Block
(16), Attach a Small Guide Spacer (18), the
Crossbar Block, the two Crossbar Guides (15), an
MIO Thick Washer (54), and the two Tethers (70)
to the Upright (2) with another MIO x 152mm Bolt
(86), Do not tighten the Bott yet.
10
81
81
18
17
16
68
14
Metal
Cover
G roove
13
54
70
121
/-
86
9