Weider Platinum XP800 User Manual page 7

3,
4,
insert the connector of the Upper Wire Harness
(71) into the socket of the Lower Wire Harness
(117), The connector shouJd slide easily into the
socket and snap into place, if the connector does
not slide easily and snap into place, turn the con-
nector over and then insert it,
Make sure that the connector and wires appear
as shown in the inset drawing, mFTHE CONNEC-
TOR (S NOT (NSERTED PROPERLY, THE CON-
SOLE MAY BE DAMAGED WHEN THE POWER
mSTURNED ON.
insert the Mech Frame (6) into the Base Hate (1),
Attach the Mech Frame to the Upright (2) with a
1/2" x 25mm Screw (85) and a 1/2" Lock Washer
(12), Do not tighten the Screw yet.
Attach the Mech Frame (6) to the Base Hate (1)
with four M10 Nylon Locknuts (103),
Tighten the 1/2" x 25ram Screw (85}.
Press the Rail Cap (49) onto the Leg (5), Attach
the Leg to the Rail (4) with two M10 x 64mm
Button Bolts (80), four M10 Washers (106), and
two M10 Nylon Locknuts (103),
Lubricate an M10 x 125mm Button Bolt (89) with
grease, Attach the Rail (4) to the Row Hate (28)
with the Bolt, two M10 Washers (106), two 31 mm
Spacers (30), and an M10 Nylon Locknut (103),
Do not overtighten the Locknut; the Rail must
be able to pivot easily.
Tighten the Storage Knob (29) into the Row Hate
(28) and the Rail (4),
\4
103
106
49
103
12
106
3O
85
80
Lubricate
Red
Wire
89
7