Assembly And Setup; Tools Required; Unpacking And Assembly - Star Trac Fitness P-TBTx Owner's Manual

A
SSEMBLY AND
Use the following procedures to unpack and assemble your

TOOLS REQUIRED

Hex (Allen) Key, 3/16-inch
I
Hex (Allen) Key, 5 mm
I
Screwdriver, Phillips #2
I

UNPACKING AND ASSEMBLY

Remove the top and sides of the shipping carton.
Remove the display box and upper body arms and set aside
Remove the remaining foam packing inserts and the protective bagging from the
TOTAL BODY TRAINER.
Using a #2 Phillips screwdriver, remove the back cover from the display by removing
six #8 X 1/2" screws. RETAIN THE SCREWS.
While holding the display in position near the neck of the TOTAL BODY TRAINER,
route the display cable connector through the cutout in the display mounting
bracket.
Slide the display mounting bracket onto the neck of the TOTAL BODY TRAINER until
the four holes in the bracket are aligned with the holes in the neck.
NOTE: Be sure not to pinch the display cable under the mounting bracket.
STAR TRAC TOTAL BODY TRAINER O
S
ETUP
' M
WNER S ANUAL
.
Step 1
Step 2A
Step 2B
11