Waste Ink Pads - Epson Stylus NX105 Service Manual

Epson STYLUS NX100/NX105/SX100/SX105/TX100/TX101/TX102/TX103/TX105/TX106/TX109/ME 300
Assemble the LD Roller Assy following the procedure below.
1. Install the Clutch while aligning the guide pin of the LD
Roller Shaft with the hole of the Clutch.
2. Install the Extension Spring between the hook of the LD
Roller Shaft and that of the Clutch.
3. Install the Combination Gear to the LD Roller Shaft.
LD Roller
Hook
Extension Spring
Figure 4-97. Assembling the LD Roller Assy (2)
When installing the Retard Roller to the Retard Roller Assy,
make sure to attach it with the arrow inside as shown below.
Retard Roller
Ejecting paper side
Figure 4-98. Assembling the Retard Roller Assy
Whenever the ASF Unit is removed/replaced, the required
adjustments must be carried out.
• Chapter 5 " ADJUSTMENT" (p.100)
DISASSEMBLY/ASSEMBLY
LD Roller Shaft
Guide pin
Positioning hole
Combination Gear
Hook
Clutch
Retard Roller Assy
Feeding paper side
Disassembling the Printer Mechanism

4.5.14 Waste Ink Pads

Parts/Components need to be removed in advance:
Scanner Stand/Cover Wire(p 60), Scanner Unit
Panel Unit (p 64), Main Board (p
CR Motor/ Driven Pulley (p 75), Ink System
PF Roller (p 90), LD Roller/ ASF Unit
Removal procedure
1. Remove the Waste Ink Pads (A - F) from the Lower Housing.
Lower Housing
Waste Ink Pads (A-F)
A
Figure 4-99. Removing the Waste Ink Pads
Revision A
(p 62), Middle Housing
65), EJ Roller/ EJ Frame Assy (p 73)
(p 77), Main Frame (p 84)
(p 91)
E
C
D
B
Confidential
(p 63)
Rib
93