Epson Stylus NX105 Service Manual page 76

Color inkjet printer
Hide thumbs Also See for Stylus NX105:
Table of Contents

Advertisement

Epson STYLUS NX100/NX105/SX100/SX105/TX100/TX101/TX102/TX103/TX105/TX106/TX109/ME 300
Route the CR Motor cable through the four hooks and the two
grooves of the Lower Housing with some slack to prevent
breaking the soldered portions. (See Fig.4-45.)
Be sure to install the CR Motor with the groove facing upward.
CR Motor
Soldered Portions
Figure 4-47. Installing the CR Motor
DISASSEMBLY/ASSEMBLY
Groove
Disassembling the Printer Mechanism
When installing the Timing Belt to the Pinion Gear of the CR Motor
follow the procedure below taking care not to twist the Timing Belt.
1. Align the hooks of the Driven Pulley with the hole of the Main
Frame, and install the Driven Pulley to the Main Frame.
2. Attach the Timing Belt to the Driven Pulley with toothed side
facing inward. (See Fig.4-46.)
3. Install the Compression Spring between the protrusion of the
Driven Pulley and that of the Main Frame. (See Fig.4-46.)
4. Slide the Driven Pulley to the CR Motor (in the direction of the
arrow) taking care not to let the Timing Belt come off, and install
the Timing Belt to the Pinion Gear of the CR Motor. (See Fig.4-46.)
Driven Pulley
Figure 4-48. Installing the Driven Pulley
Whenever the CR Motor is removed/replaced, the required
adjustments must be carried out.
Chapter 5 " ADJUSTMENT" (p.100)
After replacing the Driven Pulley, be sure to perform the
required lubrication.
Chapter 6 " MAINTENANCE" (p.108)
Revision A
Main Frame
Hook
Hole
76
Confidential

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents