Lubrication - Epson Stylus NX105 Service Manual

Epson STYLUS NX100/NX105/SX100/SX105/TX100/TX101/TX102/TX103/TX105/TX106/TX109/ME 300

6.1.3 Lubrication

The type and amount of the grease used to lubricate the printer parts are determined
based on the results of the internal evaluations. Therefore, be sure to apply the
specified type and amount of the grease to the specified part of the printer mechanism
on the following occasion.
Any parts required the lubrication are replaced.
The printer is disassembled/assembled. (If necessary)
Never use oil or grease other than those specified in this
manual. Use of different types of oil or grease may damage the
component or give bad influence on the printer function.
Never apply larger amount of grease than specified in this
manual.
Table 6-1. Specified Lubricant
Type Name
Grease
G-8AF
MAINTENANCE
Supplier
EPSON Code
TBD EPSON
Overview
Refer to the following figures for the lubrication points.
Driven Pulley Holder
Figure 6-1. Lubrication on Driven Pulley Holder
Lower Housing
Figure 6-2. Lubrication on Lower Housing (1)
Revision A
<Lubrication Point>
Contact points (x 2) with the
Pulley.
<Lubrication Type>
G-8AF
<Lubrication Amount>
Size of a grain of rice
<Remarks>
Use an injector to apply G-71.
<Lubrication Point>
Contact points (x 2) with the EJ
Roller.
<Lubrication Type>
G-8AF
<Lubrication Amount>
Adequate dose
<Remarks>
Before installing the EJ Roller.
Use an injector.
110
Confidential