Epson Stylus NX105 Service Manual page 42

Epson STYLUS NX100/NX105/SX100/SX105/TX100/TX101/TX102/TX103/TX105/TX106/TX109/ME 300
Occurrence
timing Detailed phenomenon
CR position
The LD Roller is not set to the ASF home
• Operation
position and paper is always loaded from
the ASF Unit during the paper loading
• –
sequence.
Occurrence
timing Detailed phenomenon
CR position
After both surfaces were printed, the
• Operation
paper was ejected but an error is
• –
displayed.
TROUBLESHOOTING
Table 3-5. Check point for Paper out error according to each phenomenon
Defective
unit/part name
1. Check if the tip of the Change Lever is damaged.
ASF Unit
Check point for Double feed error according to each phenomenon
Table 3-6.
Defective
unit/part name
1. Check if the Extension Spring operates correctly in the
paper loading sequence.
ASF Unit
2. Check if the Paper Back Lever operates correctly in the
paper loading sequence.
Error Indications and Fault Occurrence Causes
Check point
Check point
Backside of ASF Unit
Extension Spring
Extension Spring
Paper Back Lever
Revision A
Remedy
1. Replace the Change Lever with a new one.
Remedy
1. Set the Extension Spring between the Retard
Roller Assy and the ASF Housing.
2. Set the Extension Spring between the ASF
Housing and the Paper Back Lever.
Confidential
42