Muratec Fax Machine Installation Manual page 166

Just in case
.2.3 Bad phone line conditions made fax communication impossible. Conditions
T
can change rapidly, so try the call again later.
.3.1 The page counter in your fax machine detected a document feeder error dur-
T
ing transmission. Carefully re-insert the document into the feeder and re-try
the call.
.3.2 The fax machine didn't detect the silence indicating the call had ended.
T
.4.1 The telephone line disconnected during transmission because of excessive
T
modem errors or because remote unit ran out of paper. Try the call again.
.4.2 After transmission began, poor line conditions developed. Try the call again.
T
.4.4 Poor line conditions prevented transmission. Try the call again.
T
.5.1, transmission failed (perhaps due to line noise). Conditions can change
T ECM
.5.2, rapidly, so try the call again later.
T
.5.3
T
.8.1 A compatibility error occurred.
T
.8.10 Line noise or other problems prevented line probing.
T
.8.11 The remote fax machine didn't complete the equalizer training phase.
T
5.18
"Check Message" printouts
When there's a problem with a fax call and your machine detects an error, it pro-
duces an error printout headed by the words "Check Message." This printout lists
the following information about the transmission:
• The resulting error code
• A communications error message (see "What error messages can mean," below)
• The phone number (or , if programmed) of the fax machine with which your
TTI
machine had attempted to communicate.
What error messages can mean
The error messages on Check Message printouts can mean a variety of things.
Here's a brief summary:
Error message
Check condition of remote fax.
Repeat transmission.
Line is busy.
Check received documents.
Memory full.
Dialing number is not set.
Stopped.
Possible meanings
• Remote machine malfunctioned
• No "handshake" signals from remote fax
• Wrong phone number reached
• Poor phone line conditions
• No "handshake" signals from remote fax
• Document misfeed or miscount
• Unable to reach remote machine after
attempting specified number of redial tries
• Remote machine's line was busy
• Remote machine's line didn't answer
• Remote confirmation signal not received
from remote fax
• Poor line conditions caused a poor image
• Remote fax's memory is full
• Stored phone number failed to dial properly
• Someone pressed at the remote fax
STOP
in the middle of the "handshake"