Muratec Fax Machine Installation Manual page 110

Advanced fax
9
Use the numeric keypad to enter the appropri-
ate - password for the box.
ITU T
Note: If there isn't a
ITU
box, skip to step 10.
10
Press [Enter].
11
If you want the F-Code transmission to begin
immediately every time you press the key, press [Exit] and skip to step 14.
If you want to delay the F-Code transmission, select "Delayed Tx" and press
[Enter].
12
Next, tell your fax to carry out this delayed command one of these ways:
Option 1: Perform the command once at a
certain time on a certain day of
the month. (For example, "Do this
at 5:05
PM
To select this option, use the
numeric keypad to enter the date
and time when the fax should
perform the command.
Option 2: Perform the command at a cer-
tain time each day you press the
key. (For example, "Do this at 5:05
today.")
PM
To select this option, use the
numeric keypad to enter 0, 0 and
then the time the fax should per-
form the command.
13
Press [Enter], [Exit].
14
The machine will return to step 2.
Note: When the F-Code transmission is programmed, the
appear in the programmable one-touch number list on the
Note: When the delayed transmission is programmed, the
appear in the programmable one-touch number list on the
If you want to enter or change another key's programming, repeat steps 2-14.
If you do not want to enter or change any other key's programming, press
. Your machine returns to standby mode.
RESET
3.58
- password for this
T
on the 30th.")
Programming F-Code polling
For this operation to work, three things must be true:
• The document which you're polling must exist in the remote fax's F-Code box (
standard sub-addressing/password box).
• You must know the remote fax's
box you want to poll.
To program an F-Code polling operating into a programmable one-touch key:
1
Press
MENU
The
LCD
number list.
2
Select the programmable one-touch number
that you want to program or change.
Note: If you're changing a previously stored command:
3
Press [Enter].
4
Use the numeric keypad to enter the fax num-
ber exactly as your machine should dial it,
including whatever codes your phone system
requires. The number can be up to 40 charac-
ters in length.
5
Press [Enter].
6
Select "FCodePolling" and press [Enter].
symbol will
.
LCD 7
Use the numeric keypad to enter the
address for the box to which you want to send
symbol will
the document.
.
LCD
8
Press [Enter].
- sub-address and password (if any) for each
ITU T
, , [Enter].
C
shows the programmable one-touch
If your previous command for this key was an F-Code polling opera-
tion and you want to keep this key programmed for an F-Code polling
operation, use these instructions to make changes.
If you want to assign this key to a completely different operation,
overwrite a previously stored command to the new one.
- sub-
ITU T
-
ITU T